User Manual Appendix H
GFK-1742F Jan 2020
Using VersaPro with the DSM314 467
•
Before creating a file, check the Workbench default settings to make sure that Series
90-30 is the default PLC. To do this, click Tools on the Menu bar (see Figure 15-4),
then click the Options selection. The Options dialog box will appear, as shown next:
Figure 222: Checking the VersaPro Default Settings in the Tools/Options Dialog Box
•
Make sure Series 90-30 is shown in the Default Hardware Configuration box, then
click the OK button.
•
To open a folder, click File on the Menu bar, then either click Open Folder to open an
existing one, or click New Folder to create a new one. You can also import an existing
Series 90-30 folder that was originally created in Logicmaster or Control. See the
“Folder Operations” section of Chapter 2 in the VersaPro User’s Guide, GFK-1670 for
details. For this example, click New Folder. A New Folder Wizard dialog box will
appear as shown in the next figure.
To Next Page
Loading...
