User Manual Chapter 3
GFK-1742F Jan 2020
Installing and Wiring the DSM314 60
Figure 36: Digital Servo Axis Terminal Board Assembly Side View
The following procedure should be used to convert the Digital Servo axis terminal board to
its panel mounting form. Remember to save all removed parts for possible later conversion
back to DIN-rail mounting.
1.
Carefully remove one UMK-SE 11.25-1 side element from the UMK-BE 45 base
element. If a screwdriver or other device is used, exercise extreme caution to avoid
damaging either the plastic parts or the circuit board.
2.
Slide the UMK-FE foot element off the base element. Save this part for possible
future use in converting the terminal board back to its DIN-rail mounting
configuration.
3.
Snap the side element, removed in step 1 above, back into the base element.
4.
Insert one UMK-BF mounting ear into the appropriate two holes in the side element.
Note that the mounting ear has a recessed hole for later inserting a (user supplied)
mounting screw. The recessed hole should face upwards to accommodate the
mounting screw.
5.
Repeat steps 1-4 above for the other side of the terminal board.
To Next Page
Loading...
