95
Setup DVR IP Address
When you find a usable IP address, go back to DVR menu: “Network Setup” to enter IP
address.
IP ADDRESS: Enter the DVR‟s address [192.168.11.188]
GATEWAY: Enter Router IP Address[192.168.11.001]
Subnet MASK: 255.255.255.0
NOTE You must plan on the network structure if the MIS or Network
Administrator manages your computer networking.
You should consult with the MIS or Network Administrator for the IP
address segment and port-forwarding rule on your router and for the
DVR network setup. Encore technical support will not change any
settings of your network router for Port-Forwarding setup.
7.2 DynDNS Service Overview
For DVR you can only set a static IP address. It does not support the dynamic IP. If
you have to or prefer to use dynamic IP, then it is recommended to use a DYNDNS
service.
DYNDNS is a service the maps internet domain names to IP address and works with
dynamic IP address (assigned by ISP server).
Remark: A router is needed as the interface between PC and DVR when DVR is under
internal network environment.
7.2.1 Register with DynDNS
NOTE: Encore Electronics Inc. is not affiliated to any of the DYDNS services
mentioned here. Their web site may look different from what you see in this user
manual. The steps mentioned here are only for guidance purposes only. Please
contact the DYNDS technical support if you have difficulty in creating an account or
any discrepancies that may occur between you and the DYDNS services. As of this
writing the DYDNS service is free of charge, this may not be the same by the time you
register. Please contact the DYDNS service you choose to verify before you sign up.
There are three suggestions for DYNDNS:
www.no-ip.com, www.changeip.com and www.dyndns.com
The following will use DYNDNS website: http://www.dyndns.com as example.
To Next Page
Loading...
Need help?
General
