16
3.1 Turning on the DVR
The ENDSS-4C8 „s is ready for operations after all peripherals have been properly
connected and installed. Connect the power adaptor to turn the DVR on. The DVR may
take a few seconds to startup.
When the hard drive is detected by the system, it will ask whether or not you would like
to format it. Refer to the conditions stated below to determine which course of action to
take.
Format the hard drive when:
» It is the initial installation of the hard drive (First time to install the HDD in the
DVR).
» When the hard disc drive (HDD) installed is pulled out from other devices or
computers
Do not format the hard drive when:
» The hard drive has already been formatted by the DVR and not formatted by other
devices.
The Home Screen is shown after the system is ready.
3.2 Home Screen
The Home Screen is the starting point for many functions and applications. It allows
you to setup, access, and control the surveillance video data. You may think of this
screen as a vantage point to give you instant access to video information and DVR
functions.
Release Date: May 25 2010 17:33:16
Video: PAL
Hard Drive: WDC WD7500AYPS-01ZKB Rec:02.0
715403MB…Empty Disk
DVR needs to format HDD,
All data will be lost…
Format / Cancel?
To Next Page
Loading...
Need help?
General
