40
Click on a channel you would like to mapping with a sensor. Then select the sensor type is
normally open or closed. It depends on the characteristics of the sensor you intend to use.
Not Installed: The sensor is not connected to the channel.
Normal – Open: The sensor type is in a normally open state.
Normal – Close: The sensor type is in a normally closed state.
3.6.4.4 Record Time
Set the recording time when the Sensor Mode is triggered.
The recording time as 5sec, 10sec, 15sec, 20sec, 25sec, 30sec, 45sec, 60sec, 90sec,
120sec, 150sec or 180sec.
3.6.4.5 Alarm Mode
Select the alarm mode when Sensor Mode is triggered.
Mute: No beep whatever motion is detected or not.
Buzzer-Short: Beep shortly by buzzer on main board.
Buzzer-Long: Beep long by buzzer on main board.
Alarm-Short: Short sound coming from the alarm.
Alarm-Long: Prolonged sound coming from the alarm.
3.6.4.6 Alarm Time
The Alarm Time is the duration of the beep and may be set to: “Nonstop”(no stop), 5sec,
10sec, 15sec, 20sec, 25sec, 30sec, 35sec, 40sec, 45sec, 50sec, 55sec or 60sec.
Channel Number
Alarm Setup
Motion Setup
Sensor Setup
Record Detection Activate [ Enable]
Sensor Mode [ Disable]
Sensor Mapping
Record Time [15Sec]
Alarm Mode [Mute]
Alarm Time [10Sec]
Trigger Full Screen [ OFF]
Trigger Type [Initial Trigger]
To Next Page
Loading...
Need help?
General
