57
Static IP Address: User must manually define a static IP address. Contact the
network administrator for this information.
DHCP: System gets the IP address from the router or DHCP server. Contact the
network administrator for this information.
PPPoE: The Point-to-Point Protocol over Ethernet (PPPoE) is used mainly with
DSL services where individual users connect to the DSL modem over Ethernet
and in plain Metro Ethernet networks.
Please input the PPPoE Account ID and Password provided by the ISP.
(Note: Account ID maximum in 24 characters; Password maximum in 16
characters)
GATEWAY: Define gateway IP address. Contact the network administrator for this
information.
SUBNET MASK: A sub network, or subnet, is a logically visible, distinctly
addressed part of a single Internet Protocol network. Contact the network
administrator for this information.
MAC Address: MAC address is a unique identifier assigned to most network
adapters or network interface cards (NICs) by the manufacturer for identification. It
has been set at dedicated address even reset the DVR.
NOTE You must plan on the network structure if the MIS or Network
Administrator manages the network.
Consult with the MIS or Network Administrator for the IP address
segment and port-forwarding rule for the DVR network setup.
3.9.3.3 Management / Monitoring Setup
The Management/Monitoring Setup menu addresses the management and monitoring
service for remote DVR control and viewing from the internet (i.e. Internet Explorer)
browser and PC Viewer.
MANAGEMENT/MONITORING SETUP
Management Service
Activate Service [ Enable]
Monitoring Service
Activate Service [ Enable]
Port [8000]
Video Transmission Quality [Standard]
Audio Transmission [ ON]
Management Service
Activate Service: Enables or disables the management service for allowing
remote control from IE or PC Viewer.
To Next Page
Loading...
Need help?
General
