Identification Proline Promag 53 MODBUS RS485
10 Endress+Hauser
2.2 Certificates and approvals
The devices are designed and tested to meet state-of-the-art safety requirements in accordance with
sound engineering practice. They have left the factory in a condition in which they are safe to
operate. The devices comply with the standards EN 61010 -1 "Protection Measures for Electrical
Equipment for Measurement, Control, Regulation and Laboratory Procedures" and with the
EMC requirements of IEC/EN 61326.
The measuring system described in these Operating Instructions therefore complies with the legal
requirements of the EU Directives. Endress+Hauser confirms this by affixing the CE mark to it and
by issuing the CE Declaration of Conformity.
The measuring system is in conformity with the EMC requirements of the "Australian
Communications and Media Authority (ACMA)".
The measuring device meets all the requirements of the MODBUS/TCP conformity test and holds
the "MODBUS/TCP Conformance Test Policy, Version 2.0". The measuring device has successfully
passed all the test procedures carried out and is certified by the "MODBUS/TCP Conformance Test
Laboratory" of the University of Michigan.
2.3 Registered trademarks
MODBUS
®
Registered trademark of the MODBUS Organization
KALREZ
®
and VITON
®
Registered trademarks of E.I. Du Pont de Nemours & Co., Wilmington, USA
TRI-CLAMP
®
Registered trademark of Ladish & Co., Inc., Kenosha, USA
HistoROM™, S-DAT
®
, T-DAT™, F-CHIP
®
, FieldCare
®
, Fieldcheck
®
, Applicator
®
Registered or registration-pending trademarks of Endress+Hauser Flowtec AG, Reinach, CH
To Next Page
Loading...
Need help?
General
