Endress+Hauser MODBUS RS485 - Accessories; Device-Specific Accessories; Measuring Principle-Specific Accessories

Accessories Proline Promag 53 MODBUS RS485
94 Endress+Hauser
8 Accessories
Various which can be ordered separately from Endress+Hauser, are available for the transmitter and
the sensor. Detailed information about the concerned can be obtained from your Endress+Hauser
service organization.
8.1 Device-specific accessories
8.2 Measuring principle-specific accessories
Accessory Description Order code
Promag 53 transmitter
Transmitter for replacement or for stock. Use the order
code to define the following specifications:
– Approvals
– Degree of protection / version
– Cable type for the remote version
–Cable entries
– Display / power supply / operation
–Software
– Outputs / inputs
53XXX – XXXXX * * * * * * * *
Conversion kit for
inputs/outputs
Conversion kit with appropriate plug-in point sub-
modules for converting the input/output configuration in
place to date to a new version.
DKUI – * *
Software packages for
Promag 53
Software add-ons on F-CHIP, can be ordered individually:
– Electrode Cleaning Circuitry (ECC)
– Batching
DK5SO – *
Accessory Description Order code
Mounting kit for
Promag 53 transmitter
Mounting kit for wall-mounted housing (remote version).
Suitable for:
• Wall mounting
• Pipe mounting
• Panel mounting
Mounting set for aluminum housings. Suitable for:
• Pipe mounting
DK5WM – *
Cable for remote version Coil and signal cables, various lengths. Reinforced cable
on request.
DK5CA – * *
Ground cable for
Promag W/P
A set consists of two ground cables. DK5GC – * * *
Ground disk for
Promag W/P
Ground disk for potential matching DK5GD * * *
Mounting kit for Promag H Mounting kit for Promag H, comprising:
– 2 process connections
–Screws
–Seals
DKH * * – * * * *
Adapter connection for
Promag A, H
Adapter connections for installing Promag 53 H instead of
Promag 30/33 A or Promag 30/33 H DN 25.
DK5HA – * * * * * *
Ground rings for Promag H If the process connections are made of PVC or PVDF,
ground rings are necessary to ensure that potential is
matched. A set comprises 2 ground rings.
DK5HR – * * * *
Set of seals for Promag H For regular replacement of the seals of the Promag H
sensor.
DK5HS – * * *
Wall-mounting kit for
Promag H
Wall-mounting kit for the Promag H sensor. DK5HM – * *
Welding jig for Promag H Weld nipples as process connection:
Welding jig for installation in pipes.
DK5HW – * * *