Proline Promag 53 MODBUS RS485 Troubleshooting
Endress+Hauser 115
9.7 Return
"
Caution!
Do not return a measuring device if you are not absolutely certain that all traces of hazardous
substances have been removed, e.g. substances which have penetrated crevices or diffused through
plastic.
Costs incurred for waste disposal and injury (burns, etc.) due to inadequate cleaning will be charged
to the owner-operator.
The following steps must be taken before returning a flow measuring device to Endress+Hauser,
e.g. for repair or calibration:
• Always enclose a duly completed "Declaration of contamination" form. Only then can
Endress+Hauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per
EC REACH Regulation No. 1907/2006.
• Remove all residues. Pay special attention to the grooves for seals and crevices which could
contain residues. This is particularly important if the substance is hazardous to health, e.g.
flammable, toxic, caustic, carcinogenic, etc.
!
Note!
You will find a preprinted "Declaration of contamination" form at the back of these Operating
Instructions.
9.8 Disposal
Observe the regulations applicable in your country!
9.9 Software history
Date Software version Changes to software Operating
Instructions
07.2009 3.04.XX Introduction of Calf history 71108004/12.09
10.2005 3.01.XX - 71005396/10.05
To Next Page
Loading...
Need help?
General
