Commissioning Proline Promag 53 MODBUS RS485
80 Endress+Hauser
6.3 Quick Setup
In the case of measuring devices without a local display, the individual parameters and functions
must be configured via the configuration program, e.g. FieldCare.
If the measuring device is equipped with a local display, all the important device parameters for
standard operation, as well as additional functions, can be configured quickly and easily by means
of the following Quick Setup menus.
6.3.1 Quick Setup "Commissioning"
!
Note!
• The display returns to the cell SETUP COMMISSIONING (1002) if you press the ESC key combination during
parameter interrogation. The stored parameters remain valid.
• The "Commissioning" Quick Setup must be carried out before one of the other Quick Setups described in these
Operating Instructions is run.
m The DELIVERY SETTINGS option sets each selected unit to the factory setting.
The ACT.SETTING option accepts the units previously set by you.
n Only units not yet configured in the current Setup are offered for selection in each cycle. The unit for mass and
volume is derived from the corresponding flow unit.
o The "YES" option remains visible until all the units have been configured.
"NO" is the only option displayed when no further units are available.
p This prompt only appears if a current output and/or pulse/frequency output is available. Only the outputs not yet
configured in the current Setup are offered for selection in each cycle.
q The "YES" option remains visible until all the outputs have been parameterized.
"NO" is the only option displayed when no further outputs are available.
r The "automatic parameterization of the display" option contains the following basic settings/factory settings
YES Main line = volume flow
Additional line = totalizer 1
Information line = operating/system condition
NO The existing (selected) settings remain.
s The BATCHING QUICK SETUP is only available when the optional software package BATCHING is installed.
t The PULSATING FLOW QUICK SETUP is only available if the device has a current output or a pulse/frequency
output.
To Next Page
Loading...
Need help?
General
