Endress+Hauser Proline Promag L 400 - Mounting the Transmitter of the Remote Version

To Next Page

To Previous Page

Proline Promag L 400 PROFIBUS DP Installation

Endress+Hauser 27

Nominal diameter Threaded fasteners Max. screw tightening torque [Nm]

[mm] [mm] Hard rubber Polyurethane PTFE

750 20 × M30 559 – –

800 20 × M30 631 – –

900 24 × M30 627 – –

1 000 24 × M30 634 – –

1 200 32 × M30 727 – –

Screw tightening torques for AS 4087, PN 16

Nominal diameter Threaded fasteners Max. screw tightening torque [Nm]

[mm] [mm] Hard rubber Polyurethane PTFE

350 12 × M24 203 – –

375 12 × M24 137 – –

400 12 × M24 226 – –

450 12 × M24 301 – –

500 16 × M24 271 – –

600 16 × M27 393 – –

700 20 × M27 330 – –

750 20 × M30 529 – –

800 20 × M33 631 – –

900 24 × M33 627 – –

1 000 24 × M33 595 – –

1 200 32 × M33 703 – –

6.2.4 Mounting the transmitter of the remote version

CAUTION

Ambient temperature too high!

Danger of electronics overheating and housing deformation.

‣

Do not exceed the permitted maximum ambient temperature (→  21).

‣

If operating outdoors: Avoid direct sunlight and exposure to weathering, particularly in

warm climatic regions.

CAUTION

Excessive force can damage the housing!

‣

Avoid excessive mechanical stress.

The transmitter of the remote version can be mounted in the following ways:

• Wall mounting

• Pipe mounting

Other manuals for Endress+Hauser Proline Promag L 400