Endress+Hauser Proline Promag L 400 - Commissioning; Function Check Requirements

Proline Promag L 400 PROFIBUS DP Commissioning
Endress+Hauser 75
10 Commissioning
10.1 Function check
Before commissioning the device, make sure that the post-installation and post-
connection checks have been performed.
• "Post-installation check" checklist (→  32)
• "Post-connection check" checklist (→  45)
10.2 Switching on the measuring device
After a successful function check, switch on the measuring device.
After a successful startup, the local display switches automatically from the startup display
to the operational display.
If nothing appears on the local display or a diagnostic message is displayed, refer to
the section on "Diagnostics and troubleshooting" (→  99).
10.3 Establishing a connection via FieldCare
• For FieldCare connection (→  64)
• For establishing a connection via FieldCare (→  65)
• For FieldCare user interface (→  66)
10.4 Configuring the device address via software
In the "Communication" submenu the device address can be set.
Navigation
"Setup" menu → Communication → Device address
10.4.1 PROFIBUS network
At time of delivery, the measuring device has the following factory setting:
Device address 126
If hardware addressing is active, software addressing is blocked (→  43)
10.5 Setting the operating language
Factory setting: English or ordered local language