Endress+Hauser Proline Promag L 400 - Configuring the Local Display

Commissioning Proline Promag L 400 PROFIBUS DP
78 Endress+Hauser
Conductivity unit
Temperature unit
Mass flow unit
Mass unit
Density unit
Parameter overview with brief description
Parameter Description Selection Factory setting
Volume flow unit Select volume flow unit.
Result
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• l/h
• gal/min (us)
Volume unit Select volume unit.
Result
The selected unit is taken from: Volume
flow unit parameter
Unit choose list Country-specific:
• l
• gal (us)
Conductivity unit Select conductivity unit.
Result
The selected unit applies for:
Simulation process variable
Unit choose list µS/cm
Temperature unit Select temperature unit.
Result
The selected unit applies for:
• Output
• Reference temperature
• Simulation process variable
Unit choose list Country-specific:
• °C (Celsius)
• °F (Fahrenheit)
Mass flow unit Select mass flow unit.
Result
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• kg/h
• lb/min
Mass unit Select mass unit.
Result
The selected unit is taken from: Mass flow
unit parameter
Unit choose list Country-specific:
• kg
• lb
Density unit Select density unit.
Result
The selected unit applies for:
• Output
• Simulation process variable
• Density adjustment (in Expert menu)
Unit choose list Country-specific:
• kg/l
• lb/ft³
10.6.3 Configuring the local display
The Display wizard guides you systematically through all the parameters that can
configured for configuring the local display.