Endress+Hauser Proline Promag L 400 - Adapting to Process Conditions

Proline Promag L 400 PROFIBUS DP Operation
Endress+Hauser 95
Structure of the submenu
Parameter overview with brief description
Parameter Description User interface
Volume flow Displays the volume flow currently measured. Signed floating-point number
Mass flow Displays the mass flow currently calculated. Signed floating-point number
Conductivity Displays the corrected volume flow currently calculated. Signed floating-point number
11.4.2 Totalizer
The "Totalizer" submenu contains all the parameters needed to display the current
measured values for every totalizer.
Navigation
"Diagnostics" menu → Measured values → Totalizer
‣
Totalizer
Totalizer value 1 to 3
Totalizer overflow 1 to 3
Parameter overview with brief description
Parameter Prerequsite Description Selection / User
entry / User
interface
Factory setting
Assign process variable – Assignment of a process
variable to the totalizer.
• Volume flow
• Mass flow
Volume flow
Totalizer value # In the Assign process variable
parameter one of the following
options is selected:
• Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
• Condensate mass flow
• Energy flow
• Heat flow difference
Displays the current totalizer
counter value.
Signed floating-point
number
0 m³
Totalizer status # – Displays the current totalizer
status.
• Good
• Uncertain
• Bad
Good
Totalizer status (Hex) # – Displays the current status
value (hex) of the totalizer.
0 to 255 128
11.5 Adapting the measuring device to the process
conditions
The following are available for this purpose:
• Basic settings using the Setup menu(→  76)
• Advanced settings using the Advanced setup submenu(→  84)