Endress+Hauser Proline Promag L 400 - Performing a Totalizer Reset; Showing Data Logging

Operation Proline Promag L 400 PROFIBUS DP
96 Endress+Hauser
11.6 Performing a totalizer reset
In the Operation submenu the totalizers are reset:
Control Totalizer 1 to 3
Function scope of "Control Totalizer " parameter
Options Description
Totalize The totalizer is started.
Reset + hold The totaling process is stopped and the totalizer is reset to 0.
Preset + hold The totaling process is stopped and the totalizer is set to its defined start value
from the Preset value 1 to 3 parameter.
Navigation
"Operation" menu → Operation
‣
Totalizer handling
Control Totalizer 1 to 3
Preset value 1 to 3
Reset all totalizers
Parameter overview with brief description
Parameter Description Selection / User entry Factory setting
Control Totalizer 1 to 3 Control totalizer value. • Totalize
• Reset + hold
• Preset + hold
• Reset + totalize
• Preset + totalize
Totalize
Preset value # Specify start value for totalizer. Signed floating-point number 0 m³
11.7 Showing data logging
In the device, the extended function of the HistoROM must be enabled (order option) so
that the "Data logging" submenu appears. This contains all the parameters for the
measured value history.
The data logging history is also available via the FieldCare plant asset management
tool (→  65).
Function scope
• A total of 1000 measured values can be stored
• 4 logging channels
• Adjustable logging interval for data logging
• Display of the measured value trend for each logging channel in the form of a chart