Endress+Hauser Proline Promag L 400 - Configuring the Communication; Interface

Commissioning Proline Promag L 400 PROFIBUS DP
80 Endress+Hauser
Parameter Description Selection / User entry Factory setting
0% bargraph value 1 Enter 0% value for bar graph display. Signed floating-point number 0 l/h
100% bargraph value 1 Enter 100% value for bar graph display. Signed floating-point number 0.025 l/h
Value 2 display Select the measured value that is shown on
the local display.
Picklist (see 1st display value) None
Value 3 display Select the measured value that is shown on
the local display.
Picklist (see 1st display value) None
0% bargraph value 3 Enter 0% value for bar graph display. Signed floating-point number 0
100% bargraph value 3 Enter 100% value for bar graph display. Signed floating-point number 0
Value 4 display Select the measured value that is shown on
the local display.
Picklist (see 1st display value) None
10.6.4 Configuring the communication interface
The "Communication" submenu guides you systematically through all the parameters
that have to be configured for selecting and setting the communication interface.
Navigation
"Setup" menu → Communication
‣
Communication
Device address
Parameter overview with brief description
Parameter Description User entry Factory setting
Device address Enter device address. 0 to 126 126