Proline Promag L 400 PROFIBUS DP Electrical connection
Endress+Hauser 45
A0013960
5. Insert dummy plugs into unused cable entries.
7.6 Post-connection check
Are cables or the device undamaged (visual inspection)?
Do the cables comply with the requirements (→ 33)?
Do the cables have adequate strain relief?
Are all the cable glands installed, firmly tightened and leak-tight? Cable run with "water trap"
(→ 44) ?
Only for remote version: is the sensor connected to the right transmitter?
Check the serial number on the nameplate of the sensor and transmitter.
Does the supply voltage match the specifications on the transmitter nameplate ?
Is the terminal assignment correct ?
If supply voltage is present, do values appear on the display module?
Is the potential equalization established correctly (→ 41)?
Are all housing covers installed and the screws tightened with the correct tightening torque?
To Next Page
Loading...
