Endress+Hauser Proline Promag L 400 - Page 88

Commissioning Proline Promag L 400 PROFIBUS DP
88 Endress+Hauser
Parameter overview with brief description
Parameter Description Selection / User entry Factory setting
Format display Select how measured values are shown on
the display.
• 1 value, max. size
• 1 bargraph + 1 value
• 2 values
• 1 value large + 2 values
• 4 values
1 value, max. size
Value 1 display Select the measured value that is shown on
the local display.
• Volume flow
• Mass flow
• Conductivity
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Temperature
• Electronic temperature
Volume flow
0% bargraph value 1 Enter 0% value for bar graph display. Signed floating-point number 0 l/h
100% bargraph value 1 Enter 100% value for bar graph display. Signed floating-point number 0.025 l/h
Decimal places 1 Select the number of decimal places for the
display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
Value 2 display Select the measured value that is shown on
the local display.
Picklist (see 1st display value) None
Decimal places 2 Select the number of decimal places for the
display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
Value 3 display Select the measured value that is shown on
the local display.
Picklist (see 1st display value) None
0% bargraph value 3 Enter 0% value for bar graph display. Signed floating-point number 0
100% bargraph value 3 Enter 100% value for bar graph display. Signed floating-point number 0
Decimal places 3 Select the number of decimal places for the
display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
Value 4 display Select the measured value that is shown on
the local display.
Picklist (see 1st display value) None
Decimal places 4 Select the number of decimal places for the
display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx