IGMP Configuration Screen
WebView Local Management Tasks 3-45
3.25 IGMP CONFIGURATION SCREEN
When to Use
To enable IGMP (Internet Group Management Protocol) on the device, to configure IGMP
parameters, and to access the IP Multicast Registration Table screen.
How to Access
Click on IGMP on the WebView navigation frame. The IGMP Configuration screen, Figure 3-24,
displays.
Screen Example
Figure 3-24 IGMP Configuration Screen
Screen Element Descriptions
Refer to Table 3-24 for a functional description of each screen element.
Table 3-24 IGMP Configuration Screen Element Descriptions
Use this field… To…
IGMP Status Enable or disable IGMP snooping on the device. This allows a host to
inform the device it wants to receive transmissions addressed to a
specific multicast group.
IGMP Query Count
(2-16)
Enter the time in minutes (2 to 16) for the device to continue sending
IGMP queries before removing a port from an IGMP group.
IGMP Max
Response (10-255)
Specifies the maximum query response time after the device sends out
an IGMP Query Count. Valid values are 10 to 255 tenths of a second.
To Next Page
Loading...
Need help?
General