Epson AcuLaser C8600 - Page 187

EpsonNet WebAssist
177
11
11
11
11
11
11
11
11
11
11
11
11
❏
Ifthereareno DHCP serverson your system oronyour network
and Use a private IP address when an IP address cannot
be assigned by the DHCP server is enabled, an IP address
is automatically assigned to the Internal Print Server.
❏
Whenever the printer is turned on, you need to change the
printer port setting if Auto is selected for Get IP address.For
TCP/IP printing, we recommend selecting Manual and setting
theIPaddressmanually.
5. To assign the IP address manually, enter the IP address, the
subnet mask, and the default gateway. Be sure to give an IP
address which does not conflict with any other device on the
network.
Note:
❏
The default subnet mask is 255.255.255.0 and the default
gateway is 255.255.255.255.
❏
If there is a server or a router which functions as a gateway,
enter the IP address of the server or the router for the gateway
address. If there is no gateway, leave the default values there.
6. If you want to get a private address between 169.254.1.1 and
169.254.254.254 automatically when an IP address cannot be
obtained by the DHCP server, select
Enable
for
Use a private
IP address when an IP address cannot be assigned by the
DHCP server
.
7. When setting the IP address using the ping command, select
Manual
and
Enable
for
Set by PING
to set the IP address with
the arp/ping commands. Select
Disable
when setting the IP
address with EpsonNet WinAssist/MacAssist/WebAssist;
this prevents any unexpected change of the IP address.
Note:
Be sure to select Disable when not using ping; this prevents an
unexpected change of the IP address by EpsonNet WebManager.