3.
Load the originals at the center of the input tray in descending order of paper size with the widest at the back
and the narrowest at the front.
c
Important:
Check the following points when setting dierent sizes of originals.
❏ Slide the originals with their leading edges aligned, until they meet resistance in the ADF.
❏ Set the originals at the center of the input tray. Refer to the
u
mark on the scanner as your guide.
❏ Set the originals straight.
If not, originals may be fed askew or jammed.
Note:
Load the originals into the input tray facing down and slightly displace the top edges at an angle facing into the ADF.
4.
Slide the edge guides to t the edges of the widest original.
Specications and Placing of Originals
>
Placing Originals
>
Mixture of Originals
68
To Next Page
Loading...
