Epson EM-C800 - Changing the Administrator Password in Web Config; Configuring Product Settings

274
Note: The administrator password is required to access the full capabilities of the Web Config utility. The
default password is the product's serial number. Check the label on your product to locate the serial
number.
Parent topic: Administering Your Product
Changing the Administrator Password in Web Config
You can change the administrator password using your product's control panel or Web Config.You use
the same administrator password in all cases.
Note: If you forget your administrator password, contact Epson for support.
1. Access Web Config as an administrator and select the Product Security tab.
2. Select Change Administrator Password.
3. Enter a user name, if necessary.
4. Enter the current password, then enter and confirm the new password in the fields provided.
Note: The default password is the product's serial number. Check the label on the back of
the product to locate the serial number. The default user name is blank.
5. Click OK.
Note: To restore the administrator password to the default value, select Restore Default Settings on
the Change Administrator Password screen.
Parent topic: Administering Your Product
Configuring Product Settings
Follow the instructions in these sections to configure your product's control panel settings using the Web
Config software.
Checking Status Information
Managing the Network Connection
Setting Control Panel Options
Sending Email Notifications
Adjusting Power Saving Settings