291
If you enable Do not start if tampering is detected, the printer will display an error and stop booting. It
is not recommended to enable the Do not start if tampering is detected setting as the default setting.
1. Log in to the Web Config interface as an administrator.
2. Select the Product Security tab, then select Program Verification on Start Up.
3. Enable the Do not start if tampering is detected setting.
Parent topic: Configuring Security Settings
Restricting Domain Access
You can set up restrictions on the email domains that can be used for email notifications using the Web
Config interface.
1. Log in to the Web Config interface as an administrator.
2. Select the Product Security tab, then select the Domain Restrictions setting.
3. Select a restriction method for the Restriction Rule setting. Select Allow Sending to limit sending
emails to the listed domains or select Deny Sending to prevent emails from being sent to the listed
domains.
4. Add the necessary domains to the list by entering them in the Domain Name field and selecting
Add.
The domain is added to the list. To delete a domain, select the checkbox next to the domain name
and select Delete.
5. Select OK to apply your changes.
Parent topic: Configuring Security Settings
Using Your Product on a Secure Network
Follow the instructions in these sections to configure security features for your product on the network
using the Web Config software.
Configuring Protocols and Services in Web Config
Configuring SSL/TLS Communication
Configuring IPsec/IP Filtering
Connecting the Product to an IEEE 802.1X Network
Using a Digital Certificate
Parent topic: Administering Your Product
To Next Page
Loading...
