307
Setting Options/Description
Server ID Enter a server ID between 1 and 128 ASCII characters for
authentication on a specified RADIUS server; server ID is
verified in the subject/subjectAltName field of a server
certificate sent from the RADIUS server
Anonymous Name If you selected EAP-TTLS, PEAP-TLS or PEAP/MSCHAPv2
as the Authentication Method setting, you can configure an
anonymous name between 1 and 128 ASCII characters
instead of a user ID for phase 1 of a PEAP authentication
Encryption Strength Select one of the following encryption strengths:
High for AES256/3DES
Middle for AES256/3DES/AES128/RC4
Parent topic: Connecting the Product to an IEEE 802.1X Network
Configuring a Certificate for an IEEE 802.1X Network
If your product supports IEEE 802.1X, you can configure a certificate for the network using Web Config.
1. Access Web Config as an administrator and select the Network Security tab.
2. Under IEEE802.1X, select Client Certificate.
3. Click Import to add a new client certificate.
Note: If you have already imported a certificate published by a Certification Authority, you can copy
the certificate and use it in IEEE802.1X. To copy, select Copy From, select the certificate, and then
click Copy.
4. Click OK.
Parent topic: Connecting the Product to an IEEE 802.1X Network
IEEE 802.1X Network Status
You can check the status of the IEEE 802.1X network settings by printing a status sheet from your
product.
The network status sheet displays the information in this table for IEEE 802.1X networks.
Status ID Status description
Disable IEEE 802.1X is disabled
To Next Page
Loading...
