Epson EM-C800 - Enabling Periodic Cleaning; Powering off or Rebooting the Product Remotely; Restoring Default Product Settings

285
4. Select a search option from the Search Options drop-down list.
5. Select OK to apply your changes.
Parent topic: Configuring Product Settings
Enabling Periodic Cleaning
You can set a schedule to clean the print head using the Web Config interface.
1. Log in to the Web Config interface as an administrator.
2. Select the Device Management tab, then select the Periodic Cleaning setting.
3. Select one of the following options:
• To clean the print head after a print job, select After Printing.
• To run a cleaning cycle at a specific time, select Schedule and choose a time from the drop-down
list.
Parent topic: Configuring Product Settings
Powering Off or Rebooting the Product Remotely
You can power off or reboot the product using the Web Config interface.
1. Log in to the Web Config interface as an administrator.
2. Select the Device Management tab, then select the Power setting.
3. Select a power option from the drop down menu and select Execute.
Note: After turning off the product, you cannot access Web Config until the product is turned on again.
Parent topic: Configuring Product Settings
Restoring Default Product Settings
You can reset the product to the default settings using the Web Config interface.
1. Log in to the Web Config interface as an administrator.
2. Select the Device Management tab, then select the Restore Default Settings setting.
3. Select an option from the drop-down list. You can either restore network settings or all data and
settings.
4. Select Execute and confirm your selection to restore the product settings.