276
2. Select the Network tab, then select Basic.
3. Check or update the settings as necessary.
4. Select Next to see a summary of the network settings.
5. Select OK to accept the changes.
Note: The network connection will be temporarily interrupted to enable the new settings.
6. Select the other network options as necessary:
• Wi-Fi: Displays the current wireless network connection information. Select Setup to run the
wireless setup again or Disable Wi-Fi to turn off Wi-Fi.
• Wired LAN: Displays the current settings for the wired connection. Change the settings as
necessary and then select Next to view the changes. Confirm the information and select OK to
apply the changes.
• Wi-Fi Direct: Displays the current settings for the Wi-Fi Direct network. Adjust the settings as
necessary and select Next to view the changes. Confirm the information and select OK to apply
the changes.
Network Settings
Parent topic: Configuring Product Settings
Network Settings
The following network settings are available under the Network tab in the Web Config interface.
Basic
Setting Description
Device Name Displays the Device Name. You can enter a new name to
change the name of the device.
Location Displays a user-entered location for the printer
Obtain IP Address Sets the IP Address; if set to Manual, enter the information in
the appropriate fields
Set using BOOTP Enables IP addressing using BOOTP
Set using Automatic Private IP
Addressing (APIPA)
Enables IP addressing using APIPA
To Next Page
Loading...
