Making AP Mode Settings
is method allows you to connect the scanner directly to devices without an access point. e scanner acts as an
access point.
c
Important:
When you connect from a computer or smart device to the scanner using an AP mode connection, the scanner is
connected to the same Wi-Fi network (SSID) as the computer or smart device and communication is established
between them. Since the computer or smart device is automatically connected to other connectable Wi-Fi networks
if the scanner is turned
o,
it is not connected to the previous Wi-Fi network again if the scanner is turned on.
Connect to the scanner’s SSID in AP mode from the computer or smart device again. If you do not want to connect
every time you turn the scanner on or o, we recommend using a Wi-Fi network by connecting the scanner to an
access point.
1. Press the button on the scanner’s control panel.
e
light is lit white when AP mode connection is enabled.
2. Connect from a computer or smart device using the scanner's SSID and password.
Note:
❏ You can check the SSID and password on the label stuck to the scanner.
❏ See the documentation provided with your computer or smart device for the operating instructions.
Related Information
& “Checking the Network Connection Status” on page 165
Re-setting the Network Connection
is
section explains how to make the network connection settings and change the connection method when
replacing the wireless router or the computer.
When Replacing the Wireless Router
When you replace the wireless router, make settings for the connection between the computer or the smart device
and the scanner.
You need to make these settings if you change your Internet service provider and so on.
Making Settings for Connecting to the Computer
We recommend using the installer to connect the scanner to a computer.
To start the installer, access the following website, and then enter the product name. Go to Setup, and then start
setting up.
https://epson.sn
You can view the operating instructions in the Web Movie Manuals. Access the following URL.
https://support.epson.net/publist/vlink.php?code=NPD7126
Adding or Replacing the Computer or Devices
>
Re-setting the Network Connection
>
When Repl
…
163
To Next Page
Loading...
