Note:
❏ If the edge guides are too far apart or too tight, the original may not be fed correctly. e edge guides should be
aligned so that they lightly touch the edges of the original.
❏ Do not use a scratched Carrier Sheet or a Carrier Sheet that has been scanned more than 3,000 times.
❏ To scan both sizes and stitch them together, set the appropriate setting in the Epson Scan 2 window.
When you are using Epson ScanSmart, you can open the Epson Scan 2 screen by clicking the Settings button >
Scanner Settings tab > Scan Settings.
Select Double-Sided from Scanning Side and select Le & Right from Stitch Images in the Epson Scan 2 window.
See the Epson Scan 2 help for details.
❏ When scanning with a Carrier Sheet, select Auto Detect as the Document Size setting in Epson Scan 2 to
automatically scan the image while applying Paper Skew as the Correct Document Skew setting.
❏ e leading edge of the original must be placed at the binding part of the Carrier Sheet when scanning an original
approximately 297 mm (11.7 inches) long. Otherwise, the length of the scanned image may be longer than intended
as the scanner scans to the end of the Carrier Sheet when you select Auto Detect as the Document Size setting in the
Epson Scan 2 window.
❏ Only use a Carrier Sheet designed for your scanner. e Carrier Sheet is automatically recognized by the scanner by
detecting two small rectangular holes on the leading edge. Keep the holes in the Carrier Sheet clean and uncovered.
Related Information
& “Carrier Sheet Codes” on page 34
Placing Long Paper
Note:
Make sure there is enough space in front of the scanner for the ejected originals.
Placing Originals
>
Placing Originals in the Scanner
>
Placing Long Paper
56
To Next Page
Loading...
