Epson ES-C320W - Placing an Envelope

Note:
❏ If the edge guides are too far apart or too tight, the original may not be fed correctly. e edge guides should be
aligned so that they lightly touch the edges of the original.
❏ Do not use a scratched Carrier Sheet or a Carrier Sheet that has been scanned more than 3,000 times.
❏ If you cannot nd the size of the original to be scanned in the Document Size list in Epson Scan 2, select Auto
Detect.
❏ When scanning with a Carrier Sheet, select Auto Detect as the Document Size to automatically scan the image
while applying Paper Skew as the Correct Document Skew setting.
❏ e leading edge of the original must be placed at the binding part of the Carrier Sheet when scanning an original
approximately 297 mm (11.7 inches) long. Otherwise, the entire length of the Carrier Sheet may be scanned when
Auto Detect is selected as the Document Size.
❏ Only use a Carrier Sheet designed for your scanner. e Carrier Sheet is automatically recognized by the scanner by
detecting two small rectangular holes on the leading edge. Keep the holes clean and not covered.
Related Information
& “Carrier Sheet Codes” on page 34
Placing an Envelope
Note:
Make sure there is enough space in front of the scanner for the ejected originals.
1. Make sure the scanner position light ( ) is on.
Placing Originals > Placing Originals in the Scanner > Placing an Envelope
76