B
Wi-Fi connect button Press the WPS button on the access point, and then press
the
button for more than three seconds to connect to a
Wi-Fi network. See Related Information below for more
details. Press the
button to cancel the settings.
C
Wi-Fi on/o button Press this button for more than three seconds to turn o the
wireless signal. Press again to turn on the signal.
D
Stop button ❏ Cancels scanning.
❏ Finishes Automatic Feeding Mode.
❏ Cancels Wi-Fi settings by push button setup (WPS).
❏ Press this to release the error when a network connection
error occurs.
❏ Cancels a rmware update over a network connection.
E
Start button ❏ Starts scanning.
❏ Press this when cleaning the inside of the scanner.
Additional functions are available with dierent combinations of buttons.
+ Hold down the and buttons for more than three seconds to start PIN Code Setup
(WPS). See Related Information below for more details.
+ Turn on the scanner while holding down the button to restore the default network
settings and the administrator password. This also turns
o
the panel lock function.
Related Information
& “Adding or Replacing the Computer or Devices” on page 160
& “Resetting the Administrator Password” on page 12
Lights
Scanner Basics
>
Buttons and Lights on the Control Panel
>
Lights
26
To Next Page
Loading...
