Epson ES-C320W - Page 31

Example: For Microso Edge
Note:
❏ If a warning screen is not displayed, go to the next step.
❏ For IPv6 addresses, use the following format.
Format: http://[scanner’s IP address]/
Example: http://[2001:db8::1000:1]/
3. To change scanner settings, you need to log in as a Web Cong administrator.
Click Log in at the top-right of the screen. Enter the User Name and Current password, and then click OK.
e following provides the initial values for the Web Cong administrator information.
·User name: none (blank)
·Password: Depends on the label attached to product.
If there is a "PASSWORD" label attached to the back, enter the 8-digit number shown on the label. If there is
no "PASSWORD" label attached, enter the serial number on the label attached to the base of the product for
the initial administrator password.
Note:
If Log out is displayed at the top-right of the screen, you are already logged in as an administrator.
Related Information
& “Checking the Scanner's IP Address” on page 101
How to Run Web Cong on Windows
When connecting a computer to the scanner using WSD, follow the steps below to run Web Cong.
1. Open the scanner list on the computer.
❏ Windows 11
Click the start button, and then select Bluetooth & devices > Printers & scanners.
Scanner Basics > Information on Applications > Application for Conguring Scanner Operations (Web Cong)
31