Epson ES-C320W - Page 84

!
Caution:
❏ When placing and scanning originals that are a mixture of
dierent
sizes, originals may be fed askew because
not all of the originals are supported by the edge guides.
❏ Originals may be jammed or fed askew if you set dierent types or very dierent sizes of originals, such as in the
following cases.
· in paper and thick paper
· A4 size paper and card size paper
· Combinations of long, narrow paper that extend far beyond the input tray extension (example: long receipts
and so on)
· Combinations of folded or wrinkled paper
If originals are fed askew, check the scanned images. If the image is skewed, reduce the number of originals
loaded and scan again.
Note:
❏ Alternatively, you can scan originals of dierent paper types and thickness by loading them one by one using Automatic
Feeding Mode.
To use Automatic Feeding Mode, make the appropriate settings on the Epson Scan 2 screen.
When you are using Epson ScanSmart, you can open the Epson Scan 2 screen by clicking the Settings button > Scanner
Settings tab > Scan Settings.
On the Epson Scan 2 screen, use Automatic Feeding Mode to scan while switching the position of the scanner according
to the type of document.
1. Make sure the scanner position light ( ) is
o.
If the scanner position light ( ) is on, pull the scanner position selector to tilt the scanner forward.
Placing Originals > Placing Originals in the Scanner > Loading Batches of Originals with Dierent Paper Types an …
84