4. Click the Main Settings tab > Automatic Feeding Mode.
5.
Specify other settings for scanning on the settings screen.
Note:
You can make timeout settings to exit Automatic Feeding Mode.
Select Settings on the Document Source list to open the Document Source Settings window. Set Automatic Feeding
Mode Timeout (seconds) on the screen displayed.
6. Click Save to close the settings screen.
7. Click Close to close the Settings window.
8. Click Scan double-sided or Scan single-sided.
Automatic Feeding Mode starts.
9. Change the position of the scanner according to the type of original, adjust the edge guides, and then place the
original in the ADF.
Scanning starts automatically.
Scanning
>
Scanning from a Computer
>
Scanning in Automatic Feeding Mode
95
To Next Page
Loading...
