2. Open the paper guide cover, and tear off the printed
document using the tear-off edge of the printer.
Note:
If your paper’s perforation is not properly aligned with the tear-off
edge, you can adjust the tear-off position using the micro adjust
feature. See “Adjusting the tear-off position” on page 2-41.
c
Caution:
Never use the knob to adjust the tear-off position; this may
damage the printer or cause it to lose the tear-off position.
3. Close the paper guide cover.
When you resume printing, the printer automatically feeds the
paper back to the top-of-form position and starts printing.
To remove the remaining paper from the printer, press the
Load/Eject button to feed the paper backward to the standby
position. (See the Glossary for an explanation of the standby
position.) Then open the sprocket covers of the tractor and
remove the paper.
c
Caution:
Always tear off your printed document before you press the
Load/Eject button. Reverse feeding several pages at a time may
cause a paper jam.
1-1
2
R
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
Printing on Continuous Paper 2-15
To Next Page
Loading...
Need help?
General
