Removing the front push tractor
To remove the tractor from the front push position, follow
these steps:
1. Remove any paper from the tractor as described in the previous
section.
2. Turn off the printer.
3. Open the front paper guide by pulling the tab at the center of
the guide. Then remove the guide by grasping both sides and
pulling it straight out of the printer.
4. Press the tractor’s lock tabs, tilt the tractor up, and lift it out of
the printer.
5. Replace the front paper guide by sliding it along the printer’s
mounting slots until it locks in place. Then close the front
paper guide.
2-17nn
2-16b
L
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
2-16 Printing on Continuous Paper
To Next Page
Loading...
Need help?
General
