Printer Specifications
Mechanical
Printing method: 9-pin impact dot matrix
Printing speed: High speed draft 500 cps at 10 cpi
maximum
Draft 380 cps at 10 cpi
Near letter quality 95 cps at 10 cpi
Printing direction: Bidirectional logic seeking for text and
graphics printing. Unidirectional text or
graphics printing can be selected using
software commands.
Line spacing: 1/6-inch or programmable in 1/216-inch
increments
Printable columns: 136 columns (at 10 cpi)
Resolution:
Maximum 240 × 144 dpi (near letter quality)
Interfaces: One standard bidirectional, 8-bit, parallel
interface with IEEE 1284 nibble mode
support and one optional interface slot
Paper feed methods: Friction (front or top paper entry)
Push tractor (front or rear paper entry)
Pull tractor (front, bottom, or rear paper entry)
Push and pull tractor (additional tractor is
required for front push and pull tractor
combination)
Cut-sheet feeder (optional)
Roll paper holder (optional)
Paper feed speed: Continuous 5 inches/second
Intermittent 61 ms/line at 1/6-inch line
spacing
L
Sun-G+ Rev.C
A5 size Appendix c
97/11/13 pass 0
C-2 Specifications
To Next Page
Loading...
Need help?
General
