About the EPSON Status Monitor 2 Utility
The EPSON Status Monitor 2 utility comes with your printer
but is available only for use with Microsoft Windows 95. It
allows you to monitor your printer’s status, alerts you when
printer errors occur, and provides troubleshooting instructions
when needed.
Note:
To monitor an FX-2180 printer on a network, you must install an
optional Ethernet interface card (C82357
@ ) in your printer and use the
Status Monitor utility that comes with this card. See the manual that
comes with the interface card for instructions on using the Status
Monitor in a network environment.
Before using the Status Monitor, be sure to read the README
file on Disk 1 of the EPSON Status Monitor 2 software. You can
also find this README file in the EPSON Status Monitor 2
folder, located in the EPSON folder on your hard drive. This
file contains the latest information on the Status Monitor.
L
Sun-G+ Rev.C
A5 size Chapter 6
11/14/97 pass 0
6-2
Using EPSON Status Monitor 2
To Next Page
Loading...
