10. Make sure the printer is on. You may need to check and change
the printer driver settings as described in Chapter 4. When the
printer receives data, it automatically loads the paper and
starts printing. The printed pages are fed over the paper guide
toward the back of the printer.
11. After you finish printing, follow the steps in the next section to
tear off your printed document.
If the first printed line on your page appears too high or low,
you can fix this using the micro adjust feature as described in
“Adjusting the Top-of-Form Position” on page 2-37.
c
Caution:
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
Removing the printed document from the front push
tractor
To remove the printed document, follow these steps:
1. Make sure the Tear/Off Bin lights are flashing. (This indicates
your paper is at the current tear-off position.) You may need to
press the
Tear Off/Bin button to advance the paper to the
tear-off position.
2-35a
L
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
2-14 Printing on Continuous Paper
To Next Page
Loading...
Need help?
General
