Loading paper in the high-capacity cut-sheet feeder
You can load up to 150 ordinary single sheets, 25 plain bond envelopes, or
30 postcards in the high-capacity cut-sheet feeder. You can also load a
stack of single-sheet multi-part forms up to 15 mm (0.59 inch) thick in this
feeder.
Follow the steps below to load paper in the high-capacity cut-sheet feeder.
c
Caution:
Do not load carbon paper or labels in the high-capacity cut-sheet feeder.
1. Open the paper guide cover, and set the paper release lever to the
single-sheet position. Also make sure the paper thickness lever
(located under the printer cover) is set to the proper position for
your paper’s thickness.
2. Pull down the center support.
4-4A
center support
4-2-1
L
Sun-G+ Rev.C
A5 size Appendix A
97/11/14 pass 1
A-6 Enhancing Your Printer With Options
To Next Page
Loading...
