Using the Roll Paper Holder
The optional roll paper holder (#8310) allows you to use 8.5-inch roll
paper like that used with telex machines. This provides an inexpensive
alternative to using continuous paper for applications that require
variable paper lengths. Before you install and use the roll paper holder,
you need to assemble it.
Assembling the roll paper holder
1. Fit the arc bearings into the stand as shown.
2. Make sure you orient the stand and base plate as shown below. Then
place the base plate on the stand and fasten the two together with the
plastic spacing clips.
g3-30-1
g3-30-2
L
Sun-G+ Rev.C
A5 size Appendix A
97/11/14 pass 1
A-12 Enhancing Your Printer With Options
To Next Page
Loading...
Need help?
General
