Using the Rear Push Tractor
To use the rear push tractor, load continuous paper in the rear
slot. For information on when to use the rear push tractor, see
“Available Paper Paths” on page 3.
Loading paper onto the rear push tractor
If a tractor is installed in the pull position, you need to remove
it and replace the paper tension unit as described on page 2-33
before using the rear push tractor.
Note:
T To avoid paper jams, it is best to load thick multi-part forms using
the front or bottom slot and pull or front push tractor.
T When loading multi-part forms that are bound on only one side by
point glueing, use the rear push tractor.
c
Caution:
Do not load continuous paper with labels in the rear paper slot;
the labels may come off their backing sheet inside the printer and
cause a paper jam.
To load paper onto the rear push tractor, follow these steps:
1. Open the paper guide cover and remove the paper guide.
c
2
R
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
Printing on Continuous Paper 2-17
To Next Page
Loading...
Need help?
General
