After a few seconds, the printer loads the paper automatically
and begins printing the self test. A series of characters is
printed.
Note:
To temporarily stop the self test, press the Pause button. To resume
the test, press the
Pause button again.
3. To end the self test, press the
Pause button to stop printing and
the
Load/Eject button to eject the printed page. Then turn off
the printer.
Printing a Hex Dump
If you are an experienced user or a programmer, you can print
a hexadecimal dump to isolate communication problems
between the printer and your software program. In hex dump
mode, the printer prints all data received from the computer as
hexadecimal values.
You can print a hex dump using either single sheets or
continuous paper. See Chapter 2 for instructions on loading
continuous paper, or Chapter 3 for instructions on loading
single sheets.
Note:
Use paper that is at least 210 mm (8.3 inches) wide, such as A4- or
letter-size paper.
7
Troubleshooting
R
Sun-G+ Rev.C
A5 size Chapter 7
97/11/14 pass 1
Troubleshooting
7-19
To Next Page
Loading...
Need help?
General
