Character Tables
You can select the character tables shown in this section using the
printer’s default-setting mode or with software commands.
Note:
T Most of the character tables are the same as the PC 437 table for hex codes 00
through 7F; for these tables, only the characters for hex codes 80 through FF
are shown.
T The character tables with an asterisk (*) after the table name are available
only in some countries.
You can choose between the two IBM character tables shown below when
you select the IBM 2381 Plus emulation in the default-setting mode as
described in Chapter 5. (When you select Table 1, hex codes 00 to 1FH and
80 to 9FH are replaced; when you select Table 2, hex codes 00 to 1FH are
replaced.)
Table 1 Table 2
L
Sun-G+ Rev.C
A5 size Appendix c
97/11/13 pass 0
C-16
Specifications
To Next Page
Loading...
Need help?
General
