11. You may need to check and change the printer driver
settings as described in Chapter 4. Send a print job to the
printer. The printer starts printing from the current
position without advancing the paper. The printed pages
are fed over the paper guide toward the back of the printer.
12. After you finish printing, open the paper guide cover; then tear
off the printed document at the perforation nearest the paper
exit slot.
To remove the paper from the tractors, follow the steps under
“Removing paper from the pull tractor” on page 2-30.
Removing the pull tractor
To remove the tractor from the pull position, follow these steps:
1. Remove any paper loaded on the pull tractor as described on
page 2-30.
2. Turn off the printer. Then remove the printer cover and lift the
paper guide up and off the printer.
2-35AC
2
R
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
Printing on Continuous Paper 2-33
To Next Page
Loading...
