2. Press the Load/Eject button to feed the continuous paper
backward to the standby position. The paper is still attached to
the push tractor but is no longer in the paper path.
3. Load single sheets in the top or front paper guide as described
in Chapter 3.
Switching to printing on continuous paper
To switch from printing on single sheets to printing on
continuous paper with the front or rear push tractor, follow
these steps:
1. If a single sheet remains in the printer, press the Load/Eject
button to eject it.
c
Caution:
Never use the knob to eject paper while the printer is on; this
may damage the printer or cause it to lose the top-of-form
position.
2. Make sure that the tractor is installed in the front or rear push
position which you plan to use. To install the tractor in the
front position, see page 2-9.
3. Load continuous paper onto the front or rear push tractor as
described earlier in this chapter.
The printer loads your continuous paper automatically when
you begin printing.
L
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
2-36
Printing on Continuous Paper
To Next Page
Loading...
Need help?
General
