Plugging In the Printer
1. Make sure the printer is turned off. The printer is off when
the surface of the Operate button is even with the button
protectors as shown below.
2. Check the label on the back of the printer to make sure its
voltage matches that of your electrical outlet. Also make
sure the plug on your printer’s power cord matches your
electrical outlet.
c
Caution:
It is not possible to change the printer’s voltage. If the rated
voltage and your outlet voltage do not match, contact your
dealer for assistance. Do not plug in the power cord.
3. If the power cord is not attached to the printer, plug the
appropriate end into the AC inlet on the back of the printer.
4. Plug the power cord into a properly grounded electrical outlet.
G1-10
1
R
Sun-G+ Rev.C
A5 size Chapter 1
97/11/14 pass 0
Setting Up the Printer 1-13
To Next Page
Loading...
Need help?
General
