International character sets for the Italic table
You can select one of the following eight international character sets for
the Italic character table shown below using the default-setting mode or
the ESC R command. For example, when you select “Italic France,” the
characters in the “France” row are used in the Italic character table.
You can select one of the following seven additional sets only with the
ESC R command.
a-31
a-32
C
R
Sun-G+ Rev.C
A5 size Appendix c
97/11/13 pass 0
Specifications C-25
To Next Page
Loading...
Need help?
General
