Power supply problems
The control panel lights come on briefly, but then go off and
stay off.
Cause What to do
The printer’s voltage rating
does not match the voltage
of your electrical outlet.
Check the printer and the outlet
voltage ratings. If the voltages do
not match, unplug the printer
immediately and contact your dealer.
w
Warning:
Do not reconnect the power cord to an electrical outlet that has the
wrong voltage for your printer.
The printer does not work and the control panel lights are off
even though you turned on the printer.
Cause What to do
The power cord is not
properly plugged into the
electrical outlet or your
printer.
Press the Operate button to turn off
the printer, and make sure the power
cord is firmly plugged into the
electrical outlet and the printer, if
necessary. Then press the Operate
button to turn on the printer.
The electrical outlet does not
work.
Use a different outlet.
7
Troubleshooting
R
Sun-G+ Rev.C
A5 size Chapter 7
97/11/14 pass 1
Troubleshooting
7-5
To Next Page
Loading...
Need help?
General
