Removing the printed document from the rear push
tractor
To remove the printed document, follow these steps:
1. Make sure the Tear Off/Bin lights are flashing. (This indicates
your paper is at the current tear-off position). You may need to
press the
Tear Off/Bin
button to advance the paper to the
tear-off position.
2. Open the paper guide cover, and tear off the printed
document using the tear-off edge of the printer.
Note:
If your paper’s perforation is not properly aligned with the tear-off
edge, you can adjust the tear-off position using the micro adjust
feature. See “Adjusting the tear-off position” on page 2-41.
c
Caution:
Never use the knob to adjust the tear off position; this may
damage the printer or cause it to lose the tear-off position.
3. Close the paper guide cover.
When you resume printing, the printer automatically feeds the
paper back to the top-of-form position and starts printing.
P3-9
2
R
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
Printing on Continuous Paper 2-21
To Next Page
Loading...
