To print a hex dump, follow the steps below.
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise you may damage the
printer.
2. To enter hex dump mode, hold down both the
LF/FF and
Load/Eject buttons while you press the Operate button to
turn on the printer.
3. Open a software program and send a print job to the printer.
Your printer prints all the codes it receives in hexadecimal
format.
If characters are printable, they appear in the right column as
ASCII characters. Nonprintable codes, such as control codes,
are represented by dots. By comparing the characters printed
in the right column with the printout of the hexadecimal
codes, you can check the codes the printer is receiving.
4. To exit hex dump mode, press the
Pause button to stop printing
and the
Load/Eject button to eject the printed page(s). Then
turn off the printer.
dump
L
Sun-G+ Rev.C
A5 size Chapter 7
97/11/14 pass 1
7-20
Troubleshooting
To Next Page
Loading...
Need help?
General
